HK416 handguard/barrel compatibility

I whipped this up after spending some ridiculous amount of roubles cause I was pissed off. If you’re a HK loving boi like me I hope this helps alleviate some of the fuckery that could ensue. Maybe this will save some people their hard earned roubles(unless you’re a gate camper).

Some backstory, I was excited to build my first 416 for some quality wank material. I bough the 14.5” barrel because I knew there was a 14” keymod and the closer the rail to the end of the barrel the bigger the orgasm. I’m a sucker for shrouded suppressors but BSG is not. To my surprise, the hand guard didn’t fit and neither did ANY OTHER HANDGAURD I BOUGHT. So I said fuck it, and got the 16” barrel and low and behold THEY DIDNT FIT THAT EITHER. Low on fucks to give I bought EVERYTHING available on the market and started test fitting.

I put question marks by the ones that I audibly said “fuck” over.

20”
Crux [y]
Troy 13” [y]
HK MRS 14” [y]
HK ext quad [y]
Midwest 13.5” [y]
Midwest 9” [y]
HK quad with Flip [y]
HK quad [y]

16.5”
Crux [n]?
Troy 13” [n]?
HK MRS 14” [n]?
HK ext quad [n]?
Midwest 13.5” [n]?
Midwest 9” [y]
HK quad with Flip [y]
HK quad [y]

14.5”
Crux [n]
Troy 13” [n]?
HK MRS 14” [n]?
HK ext quad [n]?
Midwest 13.5” [n]?
Midwest 9” [y]
HK quad with Flip [y]
HK quad [y]

11”
Crux [n]
Troy 13” [n]
HK MRS 14” [n]
HK ext quad [n]
Midwest 13.5” [n]
Midwest 9” [y]
HK quad with Flip [y]
HK quad [y]

10.6”
Crux [n]
Troy 13” [n]
HK MRS 14” [n]
HK ext quad [n]
Midwest 13.5” [n]
Midwest 9” [y]
HK quad with Flip [y]
HK quad [y]

Source: https://www.reddit.com/r/EscapefromTarkov/comments/frlubg/hk416_handguardbarrel_compatibility/

leave a comment

Your email address will not be published. Required fields are marked *